Tips on how to care for you Hayden Surf Ski

By adopting the following practices; you will ensure your Hayden Surf Ski is

always in great condition and performing to it's fullest potential.
You will also have a ski that will last longer, look better and

(when the time comes to buy a new Hayden) will have a greater resale value.
· Fibreglass requires up to 2 weeks to "cure" fully (that is, to achieve it's maximum strength).

 Ideally then, you should continue to paddle your old ski for 1-2 weeks after receipt of

your new ski. And avoid if at all possible, paddling a new ski in big seas for this period.
 · Prior to use, inflate your ski with 3-5 deep breaths before placing the bung. This will increase

the air pressure within the ski and provide greater strength and rigidity (and therefore improved performance).
· Please note. Never inflate a "hot" ski. Always cool the craft down (simply roll it over in ankle deep water

 with the bung in for several minutes) if it has been in the sun or is warm prior to inflating.
Always remove the bung after use or when the ski is sitting in the sun.
· Wash the ski down with fresh water after use. Once a week remove the rudder hatch cover

and flush the area with fresh water also.
· Keep out of direct sunlight wherever possible.
· At carnivals lay upside down (in the shade if possible).

On windy days secure the ski down or lay it into the prevailing wind.
· Always transport and store ski's in a cover where possible. Foil or towelling covers are available

from Hayden Surfcraft. Foil although more expensive provides improved padding and protection.
· Should you hole or damage your craft wash it out with fresh water immediately and return it to

Hayden Surfcraft for repairs. We now have a specialist repairer on the team who will ensure

you get a professional repair and are back on the water as quickly as possible.
· When transporting your ski we suggest flat tie downs (or straps) as opposed to rope.

 Tie downs are available from Hayden Surfcraft.
· Once a month after washing down we recommend a quick spray of all moving parts

with "Easy Glide" or some such product eg. WD40.
· Once every 6 months we recommend you bring you ski back to the factory for a check up.

Where we will inspect your ski thoroughly (from testing air pressure to rudder cables)

and provide you with a free, no obligation service report.
Should you require any further information regarding this or any other matter concerning

Hayden Surfcraft, please call. We would love to hear from you.

Happy paddling,
Mick, Graham and the team